#Red alarm for septic system series
#Red alarm for septic system free

The horn can be silenced, but the alarm light. Please note if you have any standing water around tank or coming from lines/sprinkler heads or if your toilets are 'gurgling' or will not flush. The alarm horn sounds and the red beacon illuminates when a potentially threatening liquid level condition occurs. You generally have 12 hours to get service. Check to make sure the septic system has power and that there’s no standing water around the tank. The green light should be on to indicate the alarm has power the red light means the water level is getting higher than it should be.

If alarm persists, conserve water and call our office at (405) 373-1540. If your septic tank alarm gets triggered, push the red button or switch on the alarm box to turn it off.

After light turns off, toggle HWA switch back to run/up position.

Allow water level in tank to drop below alarm level.

Reset circuit breaker in control panel labeled pump.

Stop using water or turn off running toilet or faucet and allow water level in tank to drop below alarm level.

The alarm horn sounds when a potentially threatening liquid level condition occurs. The CS2004 alarm system can serve as a high or low level alarm depending on the float switch model used.

Let the septic system run a couple of pump cycles (. The CS2004 Alarm System monitors liquid levels in lift pump chambers, sump pump basins, holding tanks, sewage, agricultural, and other water applications.

Check to see if sprinklers are spraying. If the breaker happens to be on, check to see if there is any standing water surrounding the septic tanks.

Locate HWA switch on side of panel and toggle to mute/ middle position.

For systems with only one alarm light and corresponding audio, first follow the yellow alarm instructions and then the red alarm instructions. 12, 24 and 130 Volt Incandescent Bulb Type S-11. Our line includes strobe, flashing and rotating alarm lights in assorted lens colors. For each alarm light there is a corresponding audible alarm which can be muted. Ingram Products carries a variety of alarm lights in 12, 24 and 120 volts. Yellow represents an aeration alarm (COMP).

This alarm does not come with electrical plug.There are two alarms which are designated by red and yellow colored bulbs.

Can be drilled and installed to meet specific needs.

Watertight electrical cord connectors included High/Low Water Level Sensor Detector Alarm 120 dB Red Strobe Siren, Adjustable Alarm Volume, Sump Bobber Water Leak Sensor,16.

6' Power Cord with plug for easy installation Is your onsite septic system control panel in alarm with red lights and a buzzer or bell sounding This can be the result of a number of factors from mechanical. JThe Observer 500 indoor/outdoor high-water alarm from Septic Products includes a NEMA 4X (watertight) polycarbonate enclosure rated for indoor or outdoor use, 360-degree red alarm light, alarm horn, alarm test and horn silence toggle switch, and a 6-foot 120-volt AC power cord.

15' or 30' mechanical alarm float with pipe mount.

Indoor/Outdoor alarm with large light and audible horn.

Comes with a 6 foot power cord and plug for easy installation.

#Red alarm for septic system series

The VersAlarm I/O series High Water Alarm is used for monitoring liquid levels in sump and sewage basins, septic tanks and aeration systems, cisterns, and other applications.

#Red alarm for septic system free

Fast and Free same day Shipping On All High Water Alarms VersAlarm™ I/Oġ5' or 30' Mechanical alarm Float, 6' Power Cord